The Cisco Meraki Multigigabit PoE Injector allows delivery of both data and power to a Meraki access point over a single Ethernet cable, allowing deployment of devices exactly where they are needed to provide the best wireless coverage and at much lower installation cost. This PoE injector is specifically designed to meet the power needs of Cisco Meraki 802.3at-compatible multigigabit devices. Check the access point specifications to ensure compatibility.
Power – Multigigabit 802.3at PoE Injector
Description
The Cisco Meraki Multigigabit PoE Injector allows delivery of both data and power to a Meraki access point over a single Ethernet cable, allowing deployment of devices exactly where they are needed to provide the best wireless coverage and at much lower installation cost. This PoE injector is specifically designed to meet the power needs of Cisco Meraki 802.3at-compatible multigigabit devices. Check the access point specifications to ensure compatibility.
Features & Benefits
Easy Installation
Use Power Over Ethernet to supply power (and optionally data) to Cisco Meraki 802.3at compatible devices. Ethernet cable is inexpensive and easy to install. Simply plug the AC adapter into the side of the Cisco Meraki PoE injector, then plug ethernet cable into the PoE port and route that cable to your 802.3at-compatible device. To add a wired data connection, plug the data ethernet cable into the LAN port on the Meraki PoE Injector.
Technical Specifications
Power
- Input Voltage: 100 to 240 VAC
- Input Current: 1.5A maximum
- AC Input Frequency: 50-60 Hz
- Maximum Output Power: 30 W
- Powered device can be up to 100m away from power injector
Data
- Compatible with 10/100/1000Mbps Ethernet and multigigabit ethernet up to 10Gbps, full duplex
Environmental
- Operating Temperature: 14 to 113°F (-10 to 45°C)
- Storage Temperature: -40 to 158°F (-40 to 70°C)
- Operating Humidity: 5 to 90%
Additional Features
- Short-circuit protection
Physical Dimensions
- 6.5” x 3.5” x 1.7” (166 mm x 87.9 mm x 43 mm)
- Weight: 0.91 lb (410 g)
Mounting
- Mounts to walls (anchors and screws not included)
Compatibility
- Complies with 802.3at standard
- Backward compatibility with 802.3af MR-series access points
LED Indicators
- Input Power
- Fault
- Detect/connected to valid 802.3at load
Ordering Information
- MA-INJ-5-US Meraki Multigigabit 802.3at Power over Ethernet Injector (US plug)
- MA-INJ-5-EU Meraki Multigigabit 802.3at Power over Ethernet Injector (EU plug)
- MA-INJ-5-UK Meraki Multigigabit 802.3at Power over Ethernet Injector (UK plug)
- MA-INJ-5-AU Meraki Multigigabit 802.3at Power over Ethernet Injector (AU plug)
You must be logged in to post a review.
Reviews
There are no reviews yet.